2.1 Installation and setup procedures

This section describes the installation and setup procedures.

You must have Administrator permissions in Windows and superuser permissions in UNIX to perform the installation and setup procedures.

Figure 2‒1: Installation and setup procedures

Installing JP1/Base

For details about how to install and set up JP1/Base, see the JP1/Base User's Guide.

Installing NNMi

For details about how to install NNMi, see the documentation for the applicable NNMi product.

You can install NNMi at any time; however, at the time you set up JP1/IM - EG for NNMi, you will need the NNMi settings listed in the table below. Check these settings before you begin the setup of JP1/IM - EG for NNMi.

Table 2‒1: NNMi settings required during setup

Item	Description
NNMi user name	User name of the Web service client# of NNMi
NNMi password	Password of the Web service client# of NNMi
NNMi port number	Port number of the NNMi that is to be connected
NNMi language	Language of the NNMi that is to be connected
Availability of TLS	Whether TLS is to be used when NNMi is connected

#

For details about how to create a Web service client of NNMi, see the documentation for the applicable NNMi product.

To Page Top