6.7.1 Setting for the maximum number of status change events
A JP1 warning-level event can be issued when the number of monitoring object status change events exceeds a maximum value (which is 100).
In JP1/IM - Manager that has been installed as a new installation, this setting (issuance of a warning JP1 event) is initially enabled. In JP1/IM - Manager that has been installed as an upgrade installation, the same setting that was specified in the previous version is initially retained. You should change the setting as appropriate to your operation.
To specify the settings for the maximum number of status change events:
-
Terminate JP1/IM - Manager.
-
Execute the jbssetcnf command using one of the following files as the argument as appropriate:
If JP1 events are to be issued when the maximum number of status change events exceeds the maximum value: evhist_warn_event_on.conf
If JP1 events are not to be issued when the maximum number of status change events exceeds the maximum value: evhist_warn_event_off.conf
When you execute the jbssetcnf command, the setting is applied to the JP1 common definition information.
For details about the jbssetcnf command, see the JP1/Base User's Guide.
- About the setting in the file:
-
For details about the setting in the file, see Settings file for the maximum number of status change events (evhist_warn_event_xxx.conf) in Chapter 2. Definition Files in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
-
Start JP1/IM - Manager.