Hitachi

JP1 Version 12 JP1/Integrated Management 2 - Manager Configuration Guide


1.4.5 Updating IM databases (for Windows)

If you are using IM databases and you wish to upgrade JP1/Integrated Management or apply a corrected version of JP1/IM - Manager, you must first update the IM databases.

To update IM databases:

  1. Check the following service statuses:

    If the status are different from the following status, start or stop the services to create the following status.

    • If JP1/IM - MO is being used, the JP1/IM - Message Optimizer service of JP1/IM - MO is stopped at the connection source.

    • If JP1/OA is receiving JP1 event from JP1/IM2 - Manager, JP1/OA is stopped at the connection source.

    • JP1/IM2-Manager DB Server Service is running.

    • JP1/IM2-Manager Service is stopped.

  2. Execute the jimdbupdate command to check if the IM databases have been updated.

    • If the following message is output, perform step 7:

      KNAN11201-I The IM database service is the latest.

    • If the following message is output, perform the procedure beginning with step 3:

      KNAN11202-I The overwrite is necessary for the IM database.

      KNAN11207-I An update of the table schema of an IM database service is required.

      KNAN11211-I An update of the configuration files of an IM database service is required.

  3. Execute the jimdbbackup command to back up the IM databases:

    jimdbbackup -o backup-file-name -m MAINT

  4. Execute the jimdbupdate command to update the IM databases:

    jimdbupdate -i

  5. Stop the following service:

    • JP1/IM2-Manager DB Server Service

  6. Start the following service:

    • JP1/IM2-Manager DB Server Service

  7. Start the following services:

    • JP1/IM2-Manager Service

  8. If the following services were stopped in step 1, start the services.

    • JP1/IM - Message Optimizer service of JP1/IM - MO on the connection source (If using JP1/IM - MO)

    • JP1/OA on the connection source (If JP1/OA is receiving JP1 event from JP1/IM2 - Manager)

Important

Do not restore into an IM database obtained after the jimdbupdate command has been executed any IM database backup data that was obtained before the jimdbupdate command was executed.

After you have executed the jimdbupdate command, execute the jimdbbackup command again to make a new backup.