5.1.3 Upgrade installation (in Windows)

To perform an upgrade installation of JP1/DH - Server:

Note the following points when performing upgrade installation:

• If you install JP1/DH - Server Version 11 in an environment where JP1/DH - Server Version 10 has been installed, the installation wizard is incorrectly displayed in English. However, continue to install Version 11.

• If you install JP1/Data Highway - Server Starter Edition Version 11 in an environment where JP1/Data Highway - Server Starter Edition Version 10 has been installed, you have to manually install Version 11 by following the migration procedure. For details, see the Release Notes.

1. Log in to the machine in which you want to perform an upgrade installation of JP1/DH - Server as a built-in Administrator user.

2. Exit all the Windows programs.

   If another application is using a file that is part of JP1/DH - Server, the File in Use dialog box might appear. In this case, click the Cancel button to stop the upgrade installation, exit all the Windows programs, and then perform the upgrade installation again.

3. Stop JP1/DH - Server.

   From Windows Administrative Tools, open the Services window, select JP1_DH_WEB CONTAINER, and then click Stop the service.

4. Start Hitachi Integrated Installer.

   Insert the Hitachi Integrated Installer medium (CD-ROM) including JP1/DH - Server in the drive, and then start Hitachi Integrated Installer.

5. The confirmation dialog box for upgrading appears. Click the Yes button. The Start Upgrade Installation window appears.

   

6. Click the Next button. The Upgrade/Overwrite window appears.

   

7. Check the details of the installed version before starting an upgrade installation.

   

8. Click the Next button. The Ready to Install window appears.

   In the Ready to Install window, make sure that the entered information is correct.

   

9. Start an upgrade installation of JP1/DH - Server.

   In the Ready to Install window, click the Install button. The upgrade installation of JP1/DH - Server starts.

   

10. Finish the upgrade installation of JP1/DH - Server.

    When the upgrade installation is completed, the InstallShield Wizard Complete window appears. Click the Finish button to finish the upgrade installation of JP1/DH - Server.

    

11. Exit Hitachi Integrated Installer.

    Click the Finish button to exit Hitachi Integrated Installer.

    Important

    • After the upgrade installation of JP1/DH - Server is completed, start the database service (JP1_DH_DATABASE_SVR), and then set up the JP1/DH - Server environment. For details about how to set up the environment, see 5.3 Setting up the JP1/DH Web application server environment. If the JP1/DH Web server is used, see 5.4 Using the JP1/DH Web server.

    • If the upgrade installation ends due to an error, the status of the location to which JP1/DH - Server is installed is invalid. In this case, eliminate the cause of that error, start the installer again, make sure that the installer ends normally, and then complete the upgrade installation.

    • The database-related passwords are reset to p@ssw0rd. Specify them again as needed. For details, see 4.1.3 Notes on overwrite installation and upgrade installation.

To Page Top