2.3 Checking job status

After you register a job and the job and its actions run, you can view the status indicating the results. If you set a schedule, the action flow and actions run in order when the specified date and time arrives. The job enters an ended state when the last action finishes.

The following figure shows the status transition of a job and its actions.

Figure 2‒1: Overview of the status transition of a job

To see the execution results of a job, open the Checking the status dialog box from the Job Design View.

Procedure

1. Start the Job Design View and then select the Exec. on time tab.

   When you select a job, the (Checking the status) button appears.

   

2. Click the (Checking the status) button.

   The Checking the status dialog box appears.

3. Check the status of the job.

   The upper area of the Checking the status dialog box displays a job list, including the job's start time, end time, and status.

   

4. In the job list, select a job.

   A unit list appears in the lower left area of the dialog box.

   

   Note

   In the job list and unit list shown in steps 3 and 4, a job or unit is displayed in red font if the job or unit ended abnormally. For details on how abnormally-ended jobs and units are displayed, see 2.4.1(3) Checking for abnormal end.

5. In the unit list, select a unit.

   The lower right area of the dialog box displays the information of the unit, including the unit's status, the start time, and the end time.

   The Execution result button becomes available if the selected unit is an action and the command execution finished.

   

6. Click the Execution result button.

   The Execution result dialog box appears.

7. Check the execution command, standard output, and standard error output.

   

8. Click the (Close) button.

   After you check the displayed information, close the Execution result dialog box.

9. Click the (Update) button to update the information displayed in the Checking the status dialog box.

   This updates the information displayed in the Checking the status dialog box, including the update date and time.

   

10. Click the (Close) button.

    After you check the updated information, close the Checking the status dialog box.

For details on job status and action status, see the manual for Client Process Automation, which is listed in B.1 Related publications.

Organization of this section

• 2.3.1 Rerunning a job

• 2.3.2 Forcibly terminating a job

To Page Top