Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Messages


KAVV401-E

The data to the connection destination could not be sent or received.

The system failed to send or receive data with JP1/AJS3 - Manager. Alternatively, because the IP address of the connecting JP1/AJS3 - View host was not registered in the manager connection permission configuration file on the destination manager host, connection to the manager host failed.

(S)

Cancels processing.

(O)

A temporary problem may have occurred on the network. If this message appears during update or other operations, update the information, and then check whether your update or operations have become effective. If they do not take effect or if you are obtaining data, retry the same operation.

If the KAVS8040-E message was output to the integrated trace log on the destination manager host, take the corrective action specified in the KAVS8040-E message.

If this message appears frequently, an error may have occurred in JP1/AJS3 - Manager. Use log information such as the Windows event log or the syslog file on the host of JP1/AJS3 - Manager to examine the error. Then, correct the error according to the results. For details on the contents of the log file, see 1.2 Types of log information and storage locations in the manual JP1/Automatic Job Management System 3 Troubleshooting.

If this message appears immediately after you logged on to the system when the connection destination host is a Windows host, a desktop heap may be too small at the connection destination host. To prevent the consumption of the desktop heap at the connection destination host, check and correct the following settings: REUSELOGON and LOGONSHMAX environment setting parameters. For details about the environment setting parameters, see 20.4 Setting up the scheduler service environment in the JP1/Automatic Job Management System 3 Configuration Guide.

This message is output if an JP1/AJS3 - View instance with the communication encryption function disabled is connected to a manager host with the communication encryption function enabled. Match the settings of the communication encryption function between the JP1/AJS3 - View host and the manager host.