KAVS2128-E
Failed to set up embedded service. : func code=function-code error code=error-code
An attempt to set up the embedded database has failed.
- (S)
-
Terminates processing.
- (O)
-
If an attempt to install JP1/AJS3 has failed, take the following action, and then uninstall JP1/AJS3 and install it again.
If an attempt to uninstall JP1/AJS3 has failed, take the following action, and then uninstall JP1/AJS3 again.
If this message containing the same function code appears repeatedly, back up the following directory below the JP1/AJS3 installation directory, and then contact the system administrator:
Action
- For func code=1:
-
If the KAVS2127-E message was output before this message, take action according to the instructions given by the KAVS2127-E message.
If the KAVS2127-E message was not output, uninstall JP1/AJS3 and then install it again.
- For func code=2:
-
Review the environment where JP1/AJS3 is to be installed.
Make sure that there is sufficient memory and disk space.
- For func code=3:
-
Take action according to the instructions given by the KAVS2127-E message that was output before this message.
- For func code=4:
-
Review the environment where JP1/AJS3 is to be installed.
Make sure that there is sufficient memory and disk space.
- For func code=5:
-
Information about the embedded database that has already been uninstalled might remain in the JP1/AJS3 common definition information. Execute all the following commands to delete the common definition information:
jbsunsetcnf -i -h JP1_DEFAULT -c JP1AJS2 -n EMBDBINSTALL jbsunsetcnf -i -h JP1_DEFAULT -c JP1AJS2 -n EMBDB jbsunsetcnf -i -h JP1_DEFAULT -c JP1AJS2 -n EMBDBPORT
For details on the jbsunsetcnf command, see the JP1/Base User's Guide.
- For func code=6:
-
Take action for the output error code according to 2.7.9(1) Action to be taken if a JP1/AJS3 - Manager installation error occurs in the manual JP1/Automatic Job Management System 3 Troubleshooting.
- For func code=7:
-
Take action for the output error code according to 2.7.9(2) Action to be taken if a JP1/AJS3 - Manager uninstallation error occurs in the manual JP1/Automatic Job Management System 3 Troubleshooting.
Note that this message is also output to the Windows event log or syslog if execution of the following commands has failed:
-
jajs_setup command
-
jajs_setup_cluster command
-
ajsembdbuninstl command
In this case, take appropriate action for the message output to the standard output according to the action to be taken when an error occurs in each command.