5.4.2 Notes on defining a schedule information parameter

The following are notes on defining a schedule information parameter.

You cannot use a schedule information parameter to define a schedule for a unit not defined by using the ajsdefine command.
If multiple schedule information parameters are defined for one jobnet execution schedule, only the last defined schedule information parameter is valid.
For a nested jobnet, define schedules for all the units contained in the nested jobnet using the schedule information parameter. Otherwise, the system does not execute the nested jobnet.
When you omit the schedule information parameter for a job, the job is executed in the same schedule for the jobnet if it is executed.
If the execution schedule time of the lower-level jobnet is more than 24 hours after the base time of upper-level jobnet execution, the system rounds this time within 24 hours. The following gives an example of the rounding.

For the jobnet having the above configuration, the execution start time of jobnet net1 is rounded to 23:59 December 1, 20XX.