1.5 Commands

This section classifies all commands into the following groups according to the purpose of the command:

• Commands used to set up JP1/AJS3

• Commands used to customize environments

• Commands used to control JP1/AJS3

• Commands used to manipulate units

• Commands used to operate execution agents

• Commands used to execute jobs

• Commands used to manipulate embedded databases

• Commands used when an error occurs

• Commands used during special operation

The subsequent sections detail the commands in the alphabetical order of their names. Note that some of the commands are applicable to UNIX only and that others are applicable to Windows.

Organization of this section

• 1.5.1 Commands used to set up JP1/AJS3

• 1.5.2 Commands used to customize environments

• 1.5.3 Commands used to control JP1/AJS3

• 1.5.4 Commands used to manipulate units

• 1.5.5 Commands used to operate execution agents

• 1.5.6 Commands used to execute jobs

• 1.5.7 Commands used to manipulate the embedded database

• 1.5.8 Command used to manipulate the external database

• 1.5.9 Commands used when an error occurs

• 1.5.10 Commands used during special operation

To Page Top