11.2.2 Rebuilding the main site

This subsection describes how to rebuild the main site after operation has switched to the remote site, and start the copying process that prepares the main site to inherit the interim job progress from the remote site.

The following figure shows the flow of rebuilding the main site.

Figure 11‒17: Flow of rebuilding main site

To rebuild and resume activity at the main site:

Cautionary notes

The following procedure is applicable whether or not the logical host names at the main site and remote site are the same.
If the logical host names at the main site and remote site are the same, specify the logical host name of the main site for logical-host-at-remote-site as a command argument in the procedure.

Export the disaster recovery operation setup information at the remote site.

Execute the following command:
```
jajs_rpenvexport -h logical-host-at-remote-site -d output-directory
```
Rebuild the main site.

Rebuild the main site using the same procedure you used to build the remote site when setting up the JP1/AJS3 system, with reference to 9.2.3 Setting up the remote site in the JP1/Automatic Job Management System 3 Configuration Guide (for Windows) or 18.2.3 Setting up the remote site in the JP1/Automatic Job Management System 3 Configuration Guide (for UNIX).

After rebuilding the main site, use a hardware operation to initiate the copy process from the remote site to the main site.

To Page Top