Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Administration Guide


5.2.1 How to check the database usage

You can use output messages to check database usage.

Organization of this subsection

(1) When the database auto-increment function is used

Each time the database has too little remaining free space and is automatically expanded, the KFPH22024-W message is output to the Windows event log or syslog. If the KFPH22024-W message is output repeatedly, reconfigure the database and check whether the data increment value (job definition information and job execution registration information) is appropriate.

(2) When the database auto-increment function is not used

The KFPH00211-I message is output to the Windows event log or syslog when the usage rate reaches 80%, 90%, or 100%. Therefore, periodically check the Windows event log or syslog.

When the usage rate is 80%, you can avoid problems by reorganizing the database. However, when the usage rate reaches 90% or 100%, simply reorganizing the database will not eliminate the problems. Instead, you will need to delete data (job definition information and job execution registration information) or expand the database.

Cautionary note

If the backup enhancement function is enabled, see also 5.2.5(5) Considerations before using the backup enhancement function in the JP1/Automatic Job Management System 3 System Design (Configuration) Guide.