15.2.21 Settings for re-executing the dependent units
This subsection describes how to configure the settings for re-executing dependent units. For details about how to re-execute dependent units, see 4.5.11(4) Re-executing the dependent unit of a judgment job in the manual JP1/Automatic Job Management System 3 Overview.
- Organization of this subsection
(1) Definition procedure
-
Execute the following command and confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop#1 # /opt/jp1ajs2/bin/jajs_spmd_status
- #1:
-
Confirm that automatic termination has been set.
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k "definition-key" "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied to the configuration definition.
(2) Environment setting parameter
|
Definition key |
Environment setting parameter |
Explanation |
|---|---|---|
|
[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]# |
"RERUNSUBORDINATE"= |
Specifies whether dependent units are to be re-executed. |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 20.4.2(106) RERUNSUBORDINATE.