15.2 Settings for controlling job execution

This section describes how to change the settings for controlling job execution.

When you set environment setting parameters, use the jajs_config command.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference.

Organization of this section

• 15.2.1 Defining variables for work paths used during job execution

• 15.2.2 Defining search paths for a file to be transferred

• 15.2.3 Customizing the execution agent or agent attribute values created by the automatic agent definition function

• 15.2.4 Checking the messages output at the same time by a job to the standard output and standard error output

• 15.2.5 Changing the interval and number of resend attempts for job result files

• 15.2.6 Preventing duplicated reception of job result files

• 15.2.7 Placing restrictions on file reception

• 15.2.8 Changing the timeout period, interval of retries, and number of retries for TCP/IP connections

• 15.2.9 Setting the method for determining the agent host to which a job will be delivered

• 15.2.10 Setting the action to be taken if the value of a macro variable cannot be passed

• 15.2.11 Setting the handling of a macro variable when the value is a NULL string

• 15.2.12 Changing the wait time for recovery when an agent has failed

• 15.2.13 Outputting a message that reports that the maximum number of concurrently executable jobs has been reached

• 15.2.14 Changing the timeout value for the job execution control manager process

• 15.2.15 Changing the timeout value for pipe communication of the agent

• 15.2.16 Setting the timeout value for receiving notification from the job process that execution is ready

• 15.2.17 Applying SIG_DFL (setting for receiving the SIGCHLD signal) to a child process started from JP1/AJS3

• 15.2.18 Enabling the file access permission check for the ACL and secondary group settings during job execution

• 15.2.19 Placing all running jobs in an end status when a communication error occurs

• 15.2.20 Changing the settings for retries when user information is acquired

• 15.2.21 Settings for re-executing the dependent units

• 15.2.22 Operation settings when job result file transfer fails

• 15.2.23 Settings for using the return value of the preceding job in the passing information setting jobs

• 15.2.24 Placing restrictions on file transmission

• 15.2.25 Setting to increase the maximum number of execution agents that can be registered in a manager host

To Page Top