3.7.4 Items in the Attribute Settings window (Branch Node)
|
|
![[Figure]](GRAPHICS/ZUGUI24K.GIF)
The following describes the items in the Attribute Settings window.
- Organization of this subsection
(1) Node name text box
Enter the node name. An error occurs in the following cases:
-
A character string consisting of more than 128 bytes is entered. (For double-byte characters, enter 42 or fewer characters.)
-
A character string containing ASCII codes from 0x00 to 0x1F and 0x7F is entered.
(2) Node ID text box
Enter a node ID that uniquely identifies the node, by using 20 or fewer single-byte characters. Use the Node ID text box to change the node ID that is set automatically.
An error occurs in the following cases:
-
Characters other than single-byte alphanumeric characters, hyphens (-), and underscores (_) are used.
-
A node ID that is already used by another node is entered.
- Cautionary note:
-
If you specify an empty character string for the node ID, the node ID is disabled.
(3) Front/back order text box
To display this node behind or in front of other components, specify the order from the front, as a single-byte number in the range from 1 to 100. Enter 1 to bring the node to the front. Enter 100 to send the node to the back. If you enter 71 or a greater value, this node is displayed behind the relation lines that overlap the node.
The default is 1. A node that is newly added is displayed at the front.
- Cautionary note:
-
Image parts are always displayed behind other nodes and parts. Even if you specify a value in the Front/back order text box, you cannot move this node behind image parts.