3.5.4 Items in the Attribute Settings window (Terminal Node)

(1) Node name text box

Enter the node name. An error occurs in the following cases:

• A character string consisting of more than 128 bytes is entered. (For double-byte characters, enter 42 or fewer characters.)

• A character string containing ASCII codes from 0x00 to 0x1F and 0x7F is entered.

To Page Top

(2) Node ID text box

Enter a node ID that uniquely identifies the node, by using 20 or fewer single-byte characters. Use the Node ID text box to change the node ID that is set automatically.

An error occurs in the following cases:

• Characters other than single-byte alphanumeric characters, hyphens (-), and underscores (_) are used.

• A node ID that is already used by another node is entered.

Cautionary note:

If you specify an empty character string for the node ID, the node ID is disabled.

To Page Top

(3) Front/back order text box

To display this node behind or in front of other components, specify the order from the front, as a single-byte number in the range from 1 to 100. Enter 1 to bring the node to the front. Enter 100 to send the node to the back. If you enter 71 or a greater value, this node is displayed behind the relation lines that overlap the node.

The default is 1. A node that is newly added is displayed at the front.

Cautionary note:

Image parts are always displayed behind other nodes and parts. Even if you specify a value in the Front/back order text box, you cannot move this node behind image parts.

To Page Top

(4) Done button name for the previous node text box

Enter the name of the button used for transition from the previous node to this node, by using 40 or fewer double-byte characters. You cannot enter a character string containing control characters (ASCII codes from 0x00 to 0x1F and 0x7F).

If you specify an empty character string, either of the character strings shown below is displayed for the button name.

• If this node is the only transition destination of the previous node:

  Done is displayed.

• If this node is one of the transition destinations of the previous node:

  The character string consisting of Go to and the character string entered in the Node name text box for this node is displayed.

Cautionary notes:

• If there are multiple source nodes from which transition to this node occurs, you cannot change the Done button name for each source node.

• If the name specified in the Done button name for the previous node text box or the node name is too long, the button name might not be displayed completely. In such a case, revise the name specified in the text box or the node name.

  If you want to specify a character string exceeding the button width, ask the system administrator to change the button width.

To Page Top