5.10 Procedure for changing system administrators

The procedure for adding, deleting, and changing the system administrators of Navigation Platform after Navigation Platform operation has started depends on the type of user authentication being used. This section explains two procedures, one for when a directory server is used for user authentication and the other for when JP1/Base is used for user authentication.

When no user authentication is used or when a directory server is used for user authentication

Perform the following procedure:

1. Stop Navigation Platform.

2. Edit the user property file (ucnp_user.properties).

   Change the ucnp.base.server.system.admin.userids property value.

3. Start Navigation Platform.

When JP1/Base is used for user authentication

Perform the following procedure:

1. For a JP1 user that you want to add as a system administrator, set the JP1 resource group for system administrators with JP1 permission level HNP_Admin to that JP1 user.

   You can determine the JP1 resource group for system administrators by checking the ucnp.base.server.jp1auth.system.resource.group property value in the user property file (ucnp_user.properties).

2. If you want to delete a user who has already been added as a system administrator, change the JP1 resource group or JP1 permission level of that JP1 user.

3. Notify the user whose settings have been changed to re-log in to Navigation Platform.

   If the settings are changed while the target user is logged in to Navigation Platform, the user must first log out and then re-log in to apply the change.

To Page Top