KNAE08127-E

Processing was interrupted because acquisition of the command execution status failed (connection target: {0}, command identifier: {1}).

[Cause]

Possible causes are as follows:

(1) The destination host was rebooted during the connection.

(2) The destination host is overloaded.

(3) An error occurred on the connection route to the destination host.

(4) There is not enough free memory on the destination host.

(5) A temporary file directory is in an invalid state.

[Action]

Check the following, and then re-execute the service:

(1) The power status of the destination host

(2) The load on the destination host

(3) The connection route to the destination host

(4) The amount of free memory on the destination host

If the problem persists, reboot the product, and then re-execute the service. If the problem still persists, collect log information, and then contact a system administrator.

0: Host name or IP address of the destination host

1: Command ID