Hitachi

JP1 Version 12 JP1/Automatic Operation Messages


KNAE08121-E

The host did not respond to the request (connection target: {0}).

[Cause]

Possible causes are as follows:

(1) The host is overloaded.

(2) The connection with the host was reset.

(3) The connection timed out.

[Action]

Check the following, and then re-execute the service:

(1) The load on the host

(2) The route to the host

(3) The timeout value of data acquisition

If the problem persists, collect log information, and then contact your system administrator.

0: Host name or IP address of the destination host