6.5.3 Procedure to perform an overwrite or upgrade installation of JP1/AO on the active server(Windows)

To perform an overwrite or upgrade installation of JP1/AO on the active server:

1. Use the cluster software to move the resource group where the JP1/AO service is registered to the active server.

2. (If the upgrade installation target is a cluster environment built with JP1/AO version 10) Unregister the following services from the cluster software:

   • HiRDB/ClusterService _HD0

   • HAutomation Engine Web Service

   • HAutomation Engine logical-host-name

   • HBase Storage Mgmt Common Service

   • HBase Storage Mgmt Web Service

   • stopcluster command

3. When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, if the service (JP1/Base_logical-host-name) is online on the active server, bring it offline.

4. When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, Start the service (JP1/Base) on the active server.

5. Perform an overwrite or upgrade installation of JP1/AO on the active server.

6. (If the upgrade installation target is a cluster environment built with JP1/AO version 10) On the active server, create a cluster settings file (Common-Component-installation-folder¥conf¥cluster.conf).

   For details, see 5.5 Cluster settings file (cluster.conf).

7. If the HAutomation Engine Web Service is running on the active server, stop the service by executing the hcmds64srv command with the /stop /server AutomationWebService option specified.

8. Execute the setupcluster command on the active server.