5.7.4 Command that controls the HBase 64 Storage Mgmt Web SSO Service
(sc_hbase64_hweb)
This subsection provides information required to register (in the cluster software) the
sc_hbase64_hweb command, which is used to control the HBase 64 Storage
Mgmt Web SSO Service.
- Command to be used:
sc_hbase64_hweb
- Location of the command:
/opt/jp1ao/tools
Table 5‒9: Information required to register the sc_hbase64_hweb commandRegisterable mode
|
Description
|
Start
|
Use this mode to start the HBase 64 Storage Mgmt Web SSO Service.
- Format:
sc_hbase64_hweb start
- Result judgment:
Judge the result from the result of the command executed in Monitor
mode. Because the command in Start mode returns 0 as normal termination or 1
as an argument error, you cannot judge the result from the return
code.
|
Stop
|
Use this mode to stop the HBase 64 Storage Mgmt Web SSO Service.
- Format:
sc_hbase64_hweb stop
- Result judgment:
Judge the result from the result of the command executed in Monitor
mode. Because the command in Stop mode returns 0 as normal termination or 1
as an argument error, you cannot judge the result from the return
code.
|
Monitor
|
Use this mode to check whether the HBase 64 Storage Mgmt Web SSO Service is
operating normally. You need to register this mode only if you want a failover to
occur when the service fails.
- Format:
sc_hbase64_hweb status
- Result judgment:
- Return code 0 (normal)
The HBase 64 Storage Mgmt Web SSO Service is operating
normally.
- Return code 3 (not running)
The process of the HBase 64 Storage Mgmt Web SSO Service is
stopped due to a problem. If this return code is returned, assume that
an error has occurred.
|
To Page Top