Hitachi

JP1 Version 12 IT Operations Automation: Getting Started 


1.3.1 New installation of JP1/AO (in Windows)

Use the Hitachi Integrated Installer to install JP1/AO.

Before you begin

You must finish necessary tasks before installing JP1/AO, such as checking the server on which JP1/AO will be installed and installing prerequisite products.

Procedure

  1. Insert the distribution media, and then execute the Hitachi Integrated Installer.

  2. Follow the wizard to configure settings.

    Specify the JP1/AO installation folder.

  3. The information that was specified in the wizard is displayed. Check the content.

    If necessary, click the Advanced Settings button to change the following items:

    • Installation folders for the databases

    • IP address or host name of the JP1/AO server

    • Port number of the JP1/AO server

    • Whether to back up databases, and the backup folder

      As the preparation for an installation failure, specify whether to back up the databases that are shared with JP1/OA or Hitachi Command Suite products and set the backup folder. You must set these items only when JP1/OA or Hitachi Command Suite products have been already installed.

  4. Click the Install button to start the installation of JP1/AO.

    When JP1/AO is installed, the installation wizard for JP1/AO - Contents appears.

  5. Specify the installation folder for JP1/AO - Contents.

  6. The information that was specified in the wizard is displayed. Check the content.

  7. Click the Install button to start the installation of JP1/AO - Contents.

  8. In Windows, if you enter a value other than the default port number, perform the procedure to change a port number.

  9. After the installation is complete, execute the hcmds64srv command with the start option specified to start the JP1/AO services.

    Location where the commands are stored:
    Common-Component-installation-folder\bin
    Example of executing the command:

    hcmds64srv /start

Result

Caution
  • If you interrupt the installation, an empty folder might be created. If an empty folder is created, manually delete it.

  • If the installation of Common Component fails and you attempt to install it again, you cannot specify an installation destination different from the previous installation destination. Even if you enter a different installation destination, Common Component is automatically installed in the previous installation destination.