2.5.5 Configuring device monitoring
You can configure the following device monitoring settings: The conditions you set take effect immediately.
-
Collection intervals
Sets the monitoring interval for devices. Information will be collected from the registered devices at the set interval.
-
User Resource monitoring conditions
Sets the conditions to use for detecting deterioration in service performance of monitored VMs and volumes.
-
System Resource monitoring conditions
Sets the conditions to use for detecting performance bottlenecks in the monitored hardware devices, such as ESX and Hyper-V devices.
- Organization of this subsection
(1) Setting the collection intervals
Before you begin
You must have the Admin permission of JP1/OA to perform this procedure.
Procedure
In the Administration tab, select Monitoring Settings and then Collection Intervals.
In the Collection Intervals window, click Edit Collection Intervals.
Change the conditions in the Edit Collection Intervals dialog box.
- Note
-
-
After the operation has started, you can check Last Duration and Max Duration records, and use the records as a reference for adjusting the collection intervals.
-
If you have changed the system configuration, click the Reset Max button to reset Max Duration, and then change Max Duration as needed.
-
Click OK.
(2) Setting monitoring conditions for user resources
Procedure
-
In the Administration tab, select Monitoring Settings and then User Resource Thresholds.
-
In the Profile Name area of the User Resource Thresholds window, select the check box for the profile whose conditions you want to change, and then click Edit Threshold Profile.
-
Change the conditions in the Edit User Resource Threshold Profile dialog box.
-
Click OK.
(3) Setting monitoring conditions for system resources
Procedure
In the Administration tab, select Monitoring Settings and then System Resource Thresholds.
In the Profile Name area of the System Resource Thresholds window, select the check box for the profile whose conditions you want to change, and then click Edit Threshold Profile.
Change the conditions in the Edit System Resource Threshold Profile dialog box.
Click OK.
Next steps
Configure email notification.