2.1.5 Reinstalling JP1/Script

Reinstallation installs the same version of JP1/Script as the one that is already installed. The existing JP1/Script installation folder and settings will be inherited after reinstallation.

The following describes how to reinstall JP1/Script.

To reinstall JP1/Script:

1. If the output folder for JP1/Script management files has been changed to a folder on the shared disk, make the shared disk online.

   If you install JP1/Script with the shared disk offline, automatic startup setting might be disabled.

2. Log on with administrator permissions.

   If you logged on using an account without administrator permissions, installation will fail.

3. Exit all active JP1/Script programs.

   Installation will not succeed unless all programs are terminated.

4. Set the JP1/Script installation medium.

   The JP1/Script Install dialog box appears.

5. Check the program that you want to install, and then click the Next button.

6. Click the Install button.

   Installation starts, and the dialog box indicating the progress of installation appears.

7. In the Install Complete dialog box, click the Finish button.

8. Restart the computer.

   Important note

   Reinstalling JP1/Script deletes the correction patches that have been applied. Apply the patches again after reinstallation.

Remote installation (software distribution) using JP1/Software Distribution

JP1/Script supports remote installation by JP1/Software Distribution.

For details about the actual procedure for remote installation when JP1/Software Distribution is used, see the JP1/Software Distribution Administrator's Guide Volume 1 (For Windows Systems).

To Page Top