4.2.12 Interval plug-in
Function
This plug-in controls the execution interval between steps.
The operator specifies the wait time for a process as the execution interval, and JP1/AO waits for the execution interval to elapse before executing succeeding steps. By using an interval plug-in, you can execute steps at fixed intervals.
|
Cautionary notes
-
The communication status and other factors might cause a discrepancy between the actual wait time and the time specified in the plug-in.
-
You cannot change the property values when you execute the service. Set the values when you create the flow.
-
You can only specify literal characters in the input property. You cannot map the value of a service property or reserved property.
-
If you stop or forcibly terminate a task during plug-in execution, any processing that is in progress is immediately terminated and the task enters Failed status.
Version
01.10.01
Tag
Control Flow
Return codes
Return code |
Description |
---|---|
0 |
Ended normally. |
A number greater than or equal to 1 (excluding 80) |
The plug-in terminated abnormally. Use the hcmds64getlogs command to acquire log information and identify the problem. |
80 |
Task execution has stopped. |
Property list
The following table describes the property.
Property key |
Property name |
Description |
Default value |
I/O type |
Required |
---|---|---|---|---|---|
interval |
Interval |
This property specifies how long to wait before executing the next step, in the range from 1 to 1,440 (seconds). |
10 |
Input |
R |
Related topics
-
hcmds64getlogs (collecting log information) in the JP1/Automatic Operation Command and API Reference