8.3.13 Procedure for checking property mapping settings during debugging
During debugging, you can check whether the values of service properties and step properties are mapped as intended.
By viewing the Debug area and Service Properties tab, you can make sure that the same values are assigned to step properties and the service properties to which they are mapped.
To check the mapping settings during debugging, check the property values at the following timing:
For mapping between step input properties and service input properties or variables:
Check the property values while the step is interrupted before the step processing is performed.
For mapping between step output properties and service output properties or variables:
If step processing is skipped, check the property values when the step is resumed after you specify the output properties and return value of the step.
Check the property values when resuming a step that was interrupted after step processing.
|
To check the property mapping settings:
In the flow area, select the step for which you want to check the step property values.
The Debug area displays the input properties and output properties of the step you selected.
Click the Service Properties tab at the bottom of the Service Builder Debug window.
The values of the service properties are displayed.
In the Debug area and Service Properties tab, make sure that the same value appears in the Property Value columns for the step property and the mapped service property.
Operation results
You can confirm that the property values are inherited as specified in mapping. If a mapped service property is different from the design or if displayed values are not appropriate, you must correct the problem in the Service Builder Edit window.
- Important
If you specify parallel as the foreachMode property of a repeated execution plug-in, values of service properties updated in a repeated execution flow executed in parallel do not appear in the Service Properties tab.