8.3.9 Operations for interrupting step executions during debugging
When you execute a debug task, you can specify the next point to go (where step execution was interrupted) in the Debug area. The table below describes the operations to execute steps during debugging. Perform appropriate operations to proceed with debugging.
Operation |
What to do |
Available when: |
Description |
Example use case |
---|---|---|---|---|
Resume# |
Click the Resume button ( |
The step is interrupted. |
Resumes execution of the interrupted step. Processing starts at the point before processing of a plug-in in the nearest step with a breakpoint set and continues through to the end of the debug task. |
|
Interrupt |
Click the Interrupt button ( |
The step is in progress. |
Executes the step up to the nearest point at which the step can be interrupted, and then interrupts the step. |
|
Step into# |
Click the Step Into button ( |
The step is interrupted. |
Executes the step up to the next point at which the step can be interrupted, and then interrupts the step. For a layering step, repeated step, or service step, the steps in the subordinate flow are also interrupted. |
|
Step over# |
Click the Step Over button ( |
The step is interrupted. |
Executes the step and then stops execution at the first point in the next step at which execution can be interrupted. For a layering step, repeated step, or service step, the steps in the subordinate flow are executed without interruption. |
|
Step return# |
Click the Step Return button ( |
The step is interrupted. |
In most cases, this operation is used for a flow subordinate to a layering step, repeated step, or service step. This operation executes steps up to the first point at which execution can be interrupted in the upper flow and interrupts execution there. For the top-level flow, this operation executes steps to the end of the debug task. |
|
Break points# |
|
The Service Builder Debug window is displayed. |
Sets breakpoints before and after plug-in processing in the selected step. When you perform the resume operation, step execution continues up to the breakpoint you have set. |
|
- #
You can perform the same operation by right-clicking the step icon in the flow area.
The figures below display the points at which step execution is interrupted when the step-into, step-over, and step return operations are performed.
Note that if you perform the step-into, step-over, or step return operation, appears on the icon of the next step in the flow area.
If step-into operation is repeated after the debug task started
Step execution is interrupted before and after processing of all plug-ins including those subordinate to the flow plug-in. However, execution cannot be interrupted after the flow plug-in has started. Therefore, execution is interrupted before plug-in processing of Step E, rather than after plug-in processing of Step B.
If step-over operation is repeated after the debug task has started
Execution is interrupted before plug-in processing of each step. However, execution of steps is not interrupted in the flow that is subordinate to the flow plug-in.
If step-return operation is performed for the flow subordinate to the flow plug-in
After all steps in the flow subordinate to the flow plug-in are executed, processing returns to the upper-level flow, and then execution is interrupted before plug-in processing of Step E.