6.2 Tasks required before an upgrade installation (when upgrading from version 10 to 11)
This section describes the tasks that you must perform before upgrading the version of JP1/AO from 10 to 11 in Windows.
- Important
-
If you upgrade JP1/AO from version 10-02 or earlier, do not uninstall JP1/AJS3 - View when there are service templates that were created in a JP1/AO environment of version 10-02 or earlier. JP1/AJS3 - View might be used when migrating service templates to Service Builder.
Before you begin
Back up the environment in case of a failure occurring during the upgrade installation. If you upgrade the version of JP1/AO from 10 to 11, you will no longer be able to restore the data that was used in version 10. If an upgrade installation fails, install JP1/AO version 10 or earlier as a new installation, and then restore the data from a backup.
If the port number used in JP1/AO version 10 or earlier has been changed from the default port number, record the current port number. If you upgrade the version to 11, the port number is reset to the default port number (22015). After the upgrade installation finishes, change the default port number to the port number that you recorded.
If the default port number (23015) for JP1/AO version 10 or earlier will no longer be used as the port number of JP1/AO, you must delete the port number from the firewall exceptions list. In version 11 or later, if you change the port number from the default port number (22015), you must review the firewall settings.
If HTTPS connections are enabled, manually back up the private key file and SSL server certificate file. After the version has been upgraded, specify the HTTPS connection settings again.