5.7 Cluster service control commands to be registered in the cluster software
If you build a cluster configuration in Linux, by registering the commands that control the JP1/AO-related resources in the cluster software, you can specify the settings for starting, stopping, monitoring, and killing resources. In JP1/AO, these commands are called cluster service control commands.
This section describes the tasks required before the cluster service control commands can be registered in the cluster software. This section also describes the cluster service control commands in detail.
For details about the procedure for registering the cluster service control commands in the cluster software, see the documentation for the cluster software.
- Organization of this section
5.7.1 Tasks required before the cluster service control commands can be registered
5.7.2 Command that controls the database for Common Component (sc_hbase64_hirdb)
5.7.3 Command that controls the HBase 64 Storage Mgmt SSO Service (sc_hbase64_hsso command)
5.7.4 Command that controls the HBase 64 Storage Mgmt Web SSO Service (sc_hbase64_hweb)
5.7.5 Command that controls the HBase 64 Storage Mgmt Web Service (sc_hbase64_web)
5.7.6 Command that controls the HAutomation Engine Web Service (sc_automation)