5.4.3 Procedures for installing JP1/AO on the active server and standby server (if Common Component is already installed)
Install JP1/AO on the active server and standby server.
To install JP1/AO on the active server and standby server:
Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.
Install JP1/AO on the active server.
Specify a path on a shared disk for the location of the database.
Specify the logical host name for the JP1/AO server host name.
For the JP1/AO installation destination, specify the same drive and folder names in the active server and standby server.
After installation, if a message is displayed indicating that a restart is required, restart the active server.
Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.
Install JP1/AO on the standby server.
Specify a path on a shared disk for the location of the database.
Specify the logical host name for the JP1/AO server host name.
For the JP1/AO installation destination, specify the same drive and folder names in the active server and standby server.
After installation, if a message is displayed indicating that a restart is required, restart the active server.