5.3.3 Procedures for installing JP1/AO on the active server and standby server

To install JP1/AO on the active server and standby server:

1. Make sure that JP1/AO or any conflicting product is not installed on either the active or standby servers.

   If it is installed, uninstall JP1/AO or conflicting product.

2. Install JP1/AO on the active server.

   If the OS is Windows, perform the following operations:

   • Specify a path to a local disk for the location of the database.

   • Specify the physical host name for the JP1/AO server host name.

   • Specify a drive and folder as the installation destination. JP1/AO will be installed in the specified path on both the active and standby servers. If you see a message indicating that a restart is required after installation, restart the active server.

   If the OS is Linux, you do not need to specify the installation destination. JP1/AO will be installed at a fixed path on the local disk.

3. Install JP1/AO on the standby server.

   If the OS is Windows, perform the following operations:

   • Specify a path to a local disk for the location of the database.

   • Specify the physical host name for the JP1/AO server host name.

   • Specify a drive and folder as the installation destination. JP1/AO will be installed in the specified path on both the active and standby servers. If you see a message indicating that a restart is required after installation, restart the standby server.

   If the OS is Linux, you do not need to specify the installation destination. JP1/AO will be installed at a fixed path on the local disk.