5.1 Procedure for installing JP1/AO in a cluster system
After checking the prerequisites, install JP1/AO in both the active server and standby server.
To install JP1/AO in a cluster system, perform the procedure described below.
Task |
Required/optional |
Reference |
|
---|---|---|---|
1 |
Check the installation prerequisites. |
Required |
|
2 |
Install JP1/AO. |
Required |
The reference depends on the current environment and the installation status of the product.# |
3 |
Install the manual on the JP1/AO server. |
Optional |
|
4 |
Install JP1/AO Content Pack. |
Optional |
- #
The procedure for installing JP1/AO differs depending on the current configuration of the environment and on whether products have been installed.
Table 5‒2: Possible environments when setting up a cluster system Current environment
JP1/AO installation status
Common Component installation status
Reference
Cluster system set up
Y
Y
N
Y
N
Cluster system not set up
N
Y
N
- Legend:
Y: installed N: not installed
Note that cluster systems built in either of the following ways are not supported:
A non-cluster environment in which JP1/AO is already operating is rebuilt in a cluster configuration later.
A Linux cluster system is newly built in an environment in which Common Component has already been installed.