7.3.4 IE Recorder Settings window
The IE Recorder Settings window is used to change the IE Recorder settings. To display this window, in the IE Recorder (main) window, from the Edit menu, choose IE Recorder Settings. The changes made in this window are not reflected in the IE Recorder action condition definition file (jpcvierec.conf).
|
|
![[Figure]](GRAPHICS/ZUV06290.GIF)
The following describes the displayed items.
- Replay Speed
-
Specify the replay speed of the IE scenario. If you change this item, the interval (the number of seconds you specified) is inserted for each operation so that you can easily check the transition status.
- Interval time:
-
Specify the interval time from 0 to 99 seconds. 1 second is set by default. The Interval time means the inserted wait time immediately after each operation (in other words, the next operation target is marked). The specified value is applied only when replaying in the IE recorder. If you specify the decimal fraction, truncate the value at the decimal point. If none is specified, the wait time is reset to the previous value. Note that this value is ignored when you replay by step, conducts the measurement test, or measure by the IE Probe so that play time does not include this value.