7.2.5 Select Scope window
When you wish to set a series of page transitions as a scope, you use the Select Scope window to define the scope by setting the scope start point and end point. To display this window, in the Web Recorder (main) window, from the Scope menu, choose Start Scope or End Scope. The following shows the Select Scope window.
|
|
![[Figure]](GRAPHICS/ZUV06060.GIF)
- Start scope list or End scope list:
-
-
When you select Start Scope on the Scope menu in the Web Recorder (main) window:
A list of scope names for which no start point has been set is displayed.
-
When you select End Scope on the Scope menu in the Web Recorder (main) window:
A list of scope names for which the start point has been set, but no end point has been set, is displayed.
-