3.1.3 Installation procedure

(1) Program installation sequence

You must install PFM - Base before you install PFM - Agent for Service Response. A PFM - Agent cannot be installed on a host on which PFM - Base has not been installed.

To install PFM - Agent and PFM - Manager on the same host, install PFM - Manager first and then PFM - Agent.

When the Store database version is updated from 1.0 to 2.0, the setup procedure differs depending on the version of PFM - Manager or PFM - Base that is already installed. For details about how to set up version 2.0 of the Store database, see 3.4.2 Updating the Store version to 2.0.

Multiple PFM - Agents installed on the same host can be installed in any order.

Figure 3‒3: Program installation procedure

To Page Top

(2) Program installation procedure

You can install Performance Management programs on a Windows host either by using the supplied medium or by using JP1/SD to perform a remote installation. For details about the method that uses JP1/SD, see the Job Management Partner 1/Software Distribution Administrator's Guide Volume 1 (for Windows systems).

Important

If user account control functionality (UAC) is enabled on the operating system, the User Account Control dialog box might be displayed during installation. If this dialog box is displayed, click the Continue button to continue installation, or click the Cancel button to cancel installation.

To install from the supplied medium:

1. Log on to the host on which you intend to install the programs as an administrator.

2. If any Performance Management services are running on the local host, stop all of them.

   The services you are going to stop are the Performance Management services running on both the physical and logical hosts. For details about how to stop services, see the chapter that explains startup and termination of Performance Management in the JP1/Performance Management User's Guide.

   In addition, if IE Recorder, IE Probe Daemon, and their services are running, stop all of them.

3. Insert the supplied medium into the machine and execute the installer.

   Proceed with installation by following the instructions of the installer that starts.

   The following items, which have been set upon the installation of PFM - Manager or PFM - Base, are displayed for your information:

   • User information

   • Installation folder

   • Program folder

4. Click the Install button to start the installation process.

To Page Top