4.4.2 Network setup
Some settings might need to be changed depending on the configuration of the network in which Performance Management is used.
In network setup, you can specify the following two items:
-
IP addresses
Specify IP addresses when Performance Management is to be used in a network connected to multiple LANs. To specify multiple IP addresses, define host names and IP addresses in the jpchosts file. The same jpchosts file that is set up must be used throughout the entire Performance Management system.
For details, see the chapter explaining installation and setup in the JP1/Performance Management Planning and Configuration Guide.
-
Port number
You can specify the port number to be used by Performance Management. To avoid operational confusion, use the same port number and service name throughout the entire Performance Management system.
For details about port number setup, see the chapter explaining installation and setup in the JP1/Performance Management Planning and Configuration Guide.