3.2.2 Flow of installation and setup for the UNIX edition
This subsection describes the procedures for installing and setting up PFM - RM for Platform.
For details about how to install and set up PFM - Manager and PFM - Web Console, see the chapter that describes installation and setup in the JP1/Performance Management Planning and Configuration Guide.
The following figure shows the procedures for installing and setting up PFM - RM for Platform.
|
|
![[Figure]](GRAPHICS/ZU020090.GIF)
For setup commands that require a user input, you can select whether to execute the commands in the interactive or non-interactive mode.
When a command is executed in the interactive mode, the user must enter values by following the instruction displayed by the command.
When a command is executed in the non-interactive mode, no user input is required because option specifications or definition files replaces the input steps required during command execution. Furthermore, batch processing or remote execution can automate the setup procedure, thereby reducing the workload on the administrator and the cost of operations. Commands in the non-interactive mode are convenient in the following cases:
-
You want to change the password used for connecting to monitoring targets on a regular basis.
-
You want to improve the efficiency of the procedure for adding multiple monitoring targets.
For details about commands, see the manual JP1/Performance Management Reference.