5.2 User settings in SLM

To use SLM, you must prepare an authentication server (JP1/Base), set up JP1 users in the JP1/Base that will be used as the authentication server, and then specify operation permissions for the JP1 users in SLM.

The following figure shows the procedure.

Figure 5‒8: Procedure for specifying user settings in SLM

For details about the authentication server that must be prepared before JP1 user settings can be specified in JP1/Base, see 5.2.1 Authentication server.

Organization of this section

• 5.2.1 Authentication server

• 5.2.2 Setting up JP1 users in JP1/Base

• 5.2.3 Specifying operation permissions for each JP1 user

• 5.2.4 Notes about user setup

To Page Top