5.2 General monitoring procedure

The following describes the procedure for monitoring the status of monitored services by using SLM. This procedure assumes that monitored services have already been registered in SLM, and that the necessary settings for monitoring have been completed.

Figure 5‒1: General procedure for monitoring the status of monitored services

Start monitoring.

For details about how to start monitoring, see 5.3.1 Starting monitoring.
Monitor the performance status of the monitored services.

You can check the status of monitored services in a window. You can verify that the SLOs are being achieved, and also check for any unusual service performance values.

The login user can obtain the detailed status of a monitored service of interest based on the overall status of the service's service group that the user is in charge of monitoring or just check the detailed status of the specific monitored service (such as a newly added service or a service that has had problems in the past).

For details about how to monitor the status of monitored services, see 5.4 Monitoring the status of monitored services.
Investigate the cause and verify recovery.

If a problem is detected while a monitored service is being monitored or investigation is needed to respond to an inquiry from a user of a monitored service, you can check the timing of the problem and past data. Based on the obtained results, you can determine the cause of the problem and take an appropriate corrective action. After the problem has been resolved, verify that the monitored service's status has returned to normal.

For details about how to check the information that supports root cause investigation, see 6.1 Support of root cause investigation when an error or warning is displayed for a monitored service.
Stop monitoring.

If you need to change monitoring item settings or SLM log output operations, you must first stop monitoring.

For details about how to stop monitoring, see (3) Procedure for stopping monitoring in 5.3.1 Starting monitoring.

To resume monitoring the monitored services, go back to step 1.

To Page Top