jp1base_setup (UNIX only)
- Organization of this page
Function
The jp1base_setup command sets the operating environment of JP1/Base. Execute this command before using JP1/Base, either in a cluster system or a non-cluster system.
Format
jp1base_setup
Required execution permission
Superuser or JP1/Base administrator permission
Command directory
/opt/jp1base/bin/
Notes
-
In version 07-00 and later of JP1/Base, this command is executed by the installer and there is no need to execute it yourself.
If you perform an overwrite installation to reinstall JP1/Base Version 06-00 on a host on which JP1/IM is installed, and then execute the jp1base_setup command, settings made by the jcocmddef command in JP1/IM revert to their defaults. You will need to set the values again, using the jcocmddef command.
-
If you execute the jp1base_setup command after setting up a logical host, the communication protocol for a physical host is set to the ANY binding method. In that case, change the communication protocol to the IP binding method, as follows:
-
Create a file containing the following contents:
[JP1_DEFAULT\JP1BASE]
"JP1_BIND_ADDR"="IP"
-
Execute the jbssetcnf command to set the above file in the common definitions.
-
-
Do not execute this command when JP1/Base is active.
Return values
0 |
Normal end |
1 |
Abnormal end |