KNAB24223-E
An error occurred in starting the service. error code: detailed-code
The service failed to start due to an invalid setting.
(S)
Cancels startup of the service.
- (O)
-
- If 001 is indicated in detailed-code:
-
The probable causes are listed below. Check and, if necessary, revise the property file for JP1 product association setting and the system property file, and then restart the service.
-
The file does not exist.
-
You do not have file access permission.
-
The file is being used by another program.
If restart of the service failed, use the data collection tool to collect data and contact the system administrator.
-
- If 002 is indicated in detailed-code:
-
Check the value of the hptl_jp1_imss_jp1base_virtual_hostname key, which specifies the logical host name of JP1/Base, and then restart the service.
- If 003 is indicated in detailed-code:
-
Make sure that the JP1/Base logical host specified for the hptl_jp1_imss_jp1base_virtual_hostname key, which specifies the logical host name of JP1/Base, in the system property file exists, and then restart the service. If restart of the service fails again, use the data collection tool to collect data and contact the system administrator.
- If 010 is indicated in detailed-code:
-
Make sure that JP1/Base is installed on the same host, and then restart the service.