9.2.9 Setting an authentication server
If you use an LDAP server or a JP1/Base authentication server as the authentication server, execute the jsschauthorityserver command following the procedure below. This procedure is not necessary if you do not use an LDAP server or a JP1/Base authentication server.
-
Execute the jsschauthorityserver command on the primary node.
For details about the jsschauthorityserver command, see jsschauthorityserver (switches the authentication method) in Chapter 11. Commands.
-
Switch the active node from the primary node to the secondary node.
-
Execute the jsschauthorityserver command on the secondary node.
For details about the jsschauthorityserver command, see jsschauthorityserver (switches the authentication method) in Chapter 11. Commands.
-
Switch the active node from the secondary node to the primary node.