9.2.8 Registering services in the cluster software
Register the JP1/IM - Service Support services in the cluster software as shown in the following table.
|
No. |
Display name |
Service name |
Dependency |
|---|---|---|---|
|
1 |
JP1/Service Support - DB Cluster Service |
HiRDBClusterService_JS0 |
When JP1/IM - Manager and JP1/AO are not linked and the JP1/Base authentication is not used:
When JP1/IM - Manager and JP1/AO are linked and the JP1/Base authentication is used:
|
|
2 |
JP1/Service Support - DB Server |
HiRDBEmbeddedEdition_JS0 |
Resource in No. 1 |
|
3 |
JP1/Service Support |
JP1_ServiceSupport |
Resource in No. 2 |
|
4 |
JP1/Service Support - Web Service |
JP1_ServiceSupport-WebService |
Resource in No. 3 |
|
5 |
JP1/Service Support - Task Service |
JP1_ServiceSupport-TaskService |
Resource in No. 2 |
|
6 |
JP1/Base Event logical-host-name# |
JP1_Base_Event logical-host-name# |
For details about dependency, see the descriptions of registration in the cluster software in the Job Management Partner 1/Base User's Guide. |
|
7 |
JP1/Base_logical-host-name# |
JP1_Base_logical-host-name# |
- #
-
logical-host-name is a logical host name set in JP1/Base. If you want to link with JP1/IM - Manager and JP1/AO, and you want to use JP1/Base authentication, specify the logical host name set for No. 4 in Table 9-7 in 9.2.5 Registering resources in the cluster software.
Select Generic Service for Resource Type. For No. 1 and No. 2, specify the settings so that if a service stops, a failover occurs without retry. As for No. 3 to No. 5, you can remain the default settings of the cluster software.
After registering services, use the cluster software to switch the active node from the secondary node to the primary node.
- When Windows Server 2008 and WSFC are used:
-
Also, specify the following settings:
-
A user with Administrator permissions must start a command prompt and then execute the following command:
cluster
![[Figure]](GRAPHICS/ZUENG020.GIF)
res"JP1/ServiceSupport-WebService"/privStartupParameters=""Note:
indicates a half-width space character.
-
Display the Properties dialog box of JP1/Service Support - Web Service, and then check if the value of Startup parameters in the General tab is blank.
-
- When Windows Server 2012 and WSFC are used:
-
Also, specify the following settings:
-
Display the Properties dialog box of JP1/Service Support - Web Service, set the value of Startup parameters in the General tab to blank, and click the OK button.
-