5.3.6 Procedure for debugging a service template again without rebuilding
After executing a debug task, you can debug the same service template again by running the debug task from the service template debugging view that is already displayed. In this case, you do not need to build the service template again.
When you initiate another debug process, JP1/AO deletes the debug service and debug task generated during the last debug process, and generates a new debug service and debug task.
To execute a new debug task without building the service template again:
-
If the debug task is in completed or failed status, click Perform Debugging in the service template debugging view.
If the debug task is still in progress, forcibly stop it.
-
In the Perform Debugging dialog box, enter the interruption settings and definition information for the debug service.
-
Click Run.
The debug task is executed.
- Important note
-
-
The Perform Debugging dialog box shows the service template as it was configured when last built by the current user. If another user edits and builds the same service template in the meantime, the changes do not apply to the contents of the service template shown in the Perform Debugging dialog box.
-
You can only debug a service template again without building it again if the service template debugging view is still displayed. If you close the service template debugging view by clicking the End Debug button or logging out of JP1/AO, you need to rebuild the service template before debugging it.
-
Related topics