5.3.5 Settings used when beginning the debug process

In the Perform Debugging dialog box, you can enter the break setting, service name, category, task name, task description, resource group, task log output level, and property values.

Table 5‒2: Items set in *Perform Debugging* dialog box
Item	Description
Interruption Settings	As the break setting for the debug task, select one of the following: Do Not Break The debug task is executed without pausing between steps. Interrupt After Each Step Execution of the debug task pauses between each step.
Service Name	Enter the name of the debug service. The default is [DEBUG]`name-of-executed-service-template`.
Category	Enter the category of the debug service. The default is `category-of-executed-service-template`.
Task Name	Enter the name of the debug task. The default is [DEBUG]`name-of-executed-service-template`_`current-time`. The format of `current-time` is YYYYMMDDhhmmss.
Task Description	Enter a description of the debug task. This field is empty by default.
Resource Group	Select the resource group in which to register the debug service. The default is All Resources.
Task Log Level	Select the level of messages output to the task log. The default is 40. The log level you select applies only to the debug task. It has no effect on the existing shared built-in service property com.hitachi.software.dna.sys.task.log.level.
Property	Set the values of the input properties of the service. Default values are assigned according to the service property definitions set when creating the service template. The property values set in this area are specific to the debug task, and do not affect service share properties elsewhere in the system. Therefore, the values you set will not affect other services that reference the service share properties.

To Page Top