14.2.5 Changing configuration
You can change the configuration related to each setting of the NNM linkage facility to match your environment.
- Notes on changing configuration:
-
-
When you manage information from multiple PFM - Managers by using NNM, use the same the same port number and connection user information for each PFM - Manager as specified in the application registration file.
-
You need to change the configuration again after the re-setup when you again set up the NNM linkage facility after changing configuration of the NNM linkage facility.
-
- Organization of this subsection
(1) Changing port numbers
The NNM linkage facility manages symbols of the NNM GUI via two managers: The object manager that processes SNMP traps as an NNM service and is installed on the same host as PFM - Manager or PFM - Base, and the map manager that is started from the NNM GUI and adds and updates symbols in the background. The jp1pcovsvr service is used to communicate between the object manager and map manager. The service uses the 22292/tcp port number by default.
- Reference note:
-
Use the jpcconf port define command to change the port number of the jp1pcovsvr service. For details on how to change the port number, see the chapter describing installation and setup in the Job Management Partner 1/Performance Management Planning and Configuration Guide. For details on the jpcconf port define command, see the chapter that describes commands in the manual Job Management Partner 1/Performance Management Reference.