Hitachi

Job Management Partner 1 Version 10 Job Management Partner 1/Performance Management Planning and Configuration Guide


5.3 Specifying and changing the Performance Management system configuration

When you have changed the setup and configuration of systems being monitored, you need to change the Performance Management system configuration. This section explains how to change the Performance Management system configuration.

Important note

You cannot change the system locale of the server while Performance Management is running. To change the system locale of the server, uninstall all the Performance Management programs and then change the system locale of the server. Afterwards, re-install the Performance Management programs.

Refer to the subsections listed below to set up and change the system configuration.

Table 5‒8: Subsections to be referenced to set up and change the system configuration

Settings

Setup

Change

Setting up or changing the network configuration

5.3.1

5.3.1

Changing the PFM - Manager for the connection destination after operation has begun

--

5.3.2

Setting up or changing monitoring host names

5.3.3

5.3.3 to 5.3.7

Renaming physical hosts after operation has begun

--

5.3.8 to 5.3.13

Legend:

--: Not applicable

Organization of this section