jftsd - starts the JP1/FTP daemon
Format
jftsd
Function
The jftsd command starts the JP1/FTP daemon. To execute this command, you need superuser permissions.
Notes
If you have used the ftsutil command to change the maximum number of concurrent transmissions, the following settings are reset to their initial status (initialized) when you start the JP1/FTP daemon:
-
Transmission log
-
Transmission number
-
Connection number
-
Protocol trace
-
Module trace
When settings are initialized, their previous status is deleted. Therefore, we recommend that you back up any needed information before you start the JP1/FTP daemon. For details about the information to back up, see (2) Log information in 3.7.1 Information that can be saved and recovered. When you restore from a backup, make sure that the maximum number of concurrent transmissions is set to the same value as when the backup was created. If the maximum number of concurrent transmissions at the time the backup was made does not match the number at the time of recovery, the JP1/FTP daemon will not start.
When you restore from initialized status, the JP1/FTP daemon might be delayed temporarily. To avoid this delay, delete the above settings beforehand. The deletion tool enables you to do this easily. For details about the deletion tool, see H. Log Information Deletion Tool after Changing the Maximum Number of Concurrent Transmissions.