H. Log Information Deletion Tool after Changing the Maximum Number of Concurrent Transmissions
If you use the ftsutil command to change the maximum number of concurrent transmissions and then start the JP1/FTP daemon, JP1/FTP will reset (initialize) the log information to the initial status.
Depending on the amount of log information, it might take a while for the JP1/FTP daemon to start. The log information deletion tool that is associated with changing the maximum number of concurrent transmissions can be used in advance to perform this initialization processing. By using this tool before you start the JP1/FTP daemon, it will not take any extra time for the JP1/FTP daemon to start.
The log information deletion tool deletes the log files listed below. For details about the log files, see A. List of Files and Directories.
-
Log file
-
Protocol trace
-
Module trace
-
Log management information
- Organization of this section