8.3.5 Messages displayed during execution of the ftssave command
The table below lists and describes the messages that might be displayed when the ftssave command is executed.
Message that is displayed |
Cause |
Action |
---|---|---|
JP1/FTP settings are saved. |
(Normal termination) |
-- |
The command syntax is incorrect. |
There is a syntax error in the command line. |
Check and, if necessary, revise the command line. |
No auto-start program settings have been registered. |
(Normal termination with a warning) |
-- |
Duplicated switch - opt. |
An option is duplicated. |
Do not specify the same option more than once. |
No transmission settings have been registered. |
(Normal termination with a warning) |
-- |
The file name is too long. |
The specified file name exceeds the maximum length. |
Specify the file name as a string of up to 259 bytes. |
The file name is not specified. |
The file name is not specified. |
Specify the file name. |
Invalid switch - opt. |
The specified option is invalid. |
Check and, if necessary, revise the option. |
No user-to-login settings have been registered. |
(Normal termination with a warning) |
-- |
Start the program as an administrator. |
The user who started the command is not an administrator (applicable to Windows Server 2008 and Windows Server 2012). |
An administrator must start the command. |
- Legend:
-
--: There is no action that can be taken.