8.3.4 Messages displayed during execution of the ftsload command
The table below lists and describes the messages that might be displayed when the ftsload command is executed.
Message that is displayed |
Cause |
Action |
---|---|---|
JP1/FTP settings are recovered. |
(Normal termination) |
-- |
This is not a JP1/FTP settings storage file. |
The specified file is not a JP1/FTP definition information file. |
Check and, if necessary, revise the definition information file. |
There is no corresponding user, so there is no auto-start program settings to be recovered. |
(Normal termination with a warning) |
-- |
The command syntax is incorrect. |
There is a syntax error in the command line. |
Check and, if necessary, revise the command line. |
Duplicated switch - opt. |
An option is duplicated. |
Do not specify the same option more than once. |
The file name is not specified. |
The name of the file to be recovered is not specified. |
Specify the name of the file to be recovered. |
There are no settings to be recovered. |
The definition information to be recovered is not in the file. |
-- |
Invalid switch - opt. |
The specified option is invalid. |
Check and, if necessary, revise the option. |
Start the program as an administrator. |
The user who started the command is not an administrator (applicable to Windows Server 2008 and Windows Server 2012). |
An administrator must start the command. |